When establishing a groundwater protection area it is of great interest to be able to estimate the transit time of the groundwater from different places of the aquifer to the withdrawal well. These estimates can be uncertain due to heterogeneities in the aquifer. As a part of the work to develop methods for a more certain delineation of protection areas, a tracer test was performed in an esker located 25 kilometres NW of the town Uppsala.The purpose of this master thesis was to perform, describe and evaluate the tracer test. Travel times from the tracer test should then enable comparison against stochastic simulated travel times of the groundwater in the area.Three dyes (rhodamine WT, uranine and naphtionate) and a salt (NaBr) were used in the tracer test. The tracers were injected in four different wells located 25 meters from a pumping well.

I was assigned to the thesis as part of a project GMA AB (Ground Machinery Applications AB) is running. The project aims to develop a new method for injection of drilled holes in rock walls. Currently, the injections usually involve cement but the basic idea of the project is to replace cement with a supplement called Silica sol.Silica sol is known as a gelling liquid. The gel time is controlled by a mixing of saline. Depending on the amount saline that gets mixed in, the gel time varies.

Periods of hypoxia are a recurring issue in Brunnsviken. Main factors that trigger hypoxia in Brunnsviken are eutrophication  due to anthropogenic emission of nutrients, stratification in the water column due to salinity and temperature differences  that prevents mixing and a sill inlet that prevents water exchange. As an attempt to improve the oxygen levels, bottom water is pumped from Brunnsviken causing aerated surface water to flow back into the basin.  The objective of this Master?s thesis was to study the change in dissolved oxygen levels due to pumping.

When protection zones for wells are delineated, it is important to acquire good knowledge about possible travel time from different points in the catchment area to the well. Often, simple analytical methods are used for estimating travel times and the assumption is made that the hydraulic conductivity is relatively homogenous within the aquifer. Nevertheless, many aquifers are strongly heterogeneous which may lead to differences between estimates and actual travel times. As a part of the process to develop improved methods for delineating protection zones for groundwater supply wells, a tracer experiment was performed in a glaciofluvial esker formation in Järlåsa. On the basis of the experiment, a numerical flow model was created for the test site.The purpose of this master?s thesis was to apply the flow model to an aquifer where the hydraulic conductivity shows great variability and should be described by a stochastic distribution.

Over an extended period of time there have been plans to establish a shared facility in Lennheden to extract groundwater from the Badelunda esker to provide drinking water for the cities of Borlänge and Falun. The city of Falun is dissatisfied with the quality of its drinking water and the city of Borlänge is concerned about the risk of contamination of its existing groundwater supply at its current location. To provide a basis for a decision on this issue, the company Midvatten AB has been commissioned to perform hydrogeological investigations in the area of Lennheden.The purpose of this thesis is to design a functional groundwater model of the area between Lennheden, place of planned extraction, and Övre Tjärna, place of existing extraction, to get a better understanding of the groundwater situation in the area. A groundwater model enables simulations of different scenarios in risk assessment and contaminant transport. The aim of the thesis is that the model can be used as an aid in Midvatten?s investigations in Lennheden and that it also can be used in future projects in the area.The model has been made in Processing Modflow 5.3 and encompasses an area of 19,5 × 11 km along the Badelunda esker and the river Dalälven between Djurmo and Frostbrunnsdalen.

Test is an area in system development. Test can be performed manually or automated. Test activities can be supported by Word documents and Excel sheets for documenting and executing test cases and as well for follow up, but there are also new test tools designed to support and facilitate the testing process and the activities of the test. This study has described manual test and identified strengths and weaknesses of manual testing with a testing tool called Microsoft Test Manager (MTM) and of manual testing using test cases and test log templates developed by the testers at Sogeti. The result that emerged from the problem and strength analysis and the analysis of literature studies and firsthand experiences (in terms of creating, documenting and executing test cases) addresses the issue of the following weaknesses and strengths.

Test bench for air bearingsThis thesis work consisted of bringing forward and defining the test parameters relevant for a test bench and constructing a test bench that can test and verify the largest existing air bearings that are of use in Micronic Laser Systems AB machines. Because the knowledge about air bearings is limited it is thought that with the help of the test bench the knowledge would increase and in that way improve the air bearings.After learning more about air bearings and their purpose at Micronic Laser Systems AB, I started the concept phase for the test bench. For each part in the test bench I consulted my two tutors, Torbjörn Hedevärn and Johan Bergqvist, at Micronic Laser Systems AB. The final concepts where documented as 3D-modells in Solidworks and some of them have been tested in Solidworks FEM-program.The test bench is designed so that, with the help of a pneumatic cylinder, 25 kilo weights are placed on the air bearing to test its stiffness, damping and the pressure performance under its surface area. To test these parameters the test bench has to have a pressure meter, accelerometer and a microcator.

This paper investigates the usability of the intelligence test Wechsler Nonverbal Scale of Ability (WNV). Twenty four children in two different age-groups were tested with WNV, 10 children between ages 5 - 6, and 14 children between ages 9 - 10. The WNV turned out to be a useful test when some verbal communication was used in the test situation. This was especially apparent among the younger children, who needed extra verbal instructions and verbal support through the different subtests. The test also contained standardized verbal instructions for all ages.

A study has been performed that investigates the variation of iron content in groundwater.The study was initiated by Midvatten AB, which noticed that the iron content in groundwater samples can vary greatly over small distances. The purpose of this study was to geochemically and geohydrologically determine the factors that influence the content of iron and manganese in groundwater from a selection of eskers in Dalarna, and determine how to best sample groundwater with the method used by Midvatten AB. An evaluation was made of how the vertical variation in soil material, water composition, pumping time and pipe material affects the content of iron in groundwater. Piper diagrams were used to study the relationship between the chemical composition of the groundwater and the content of iron and manganese in groundwater samples from the studied areas. The groundwater from the studied areas was then classified in the Piper diagrams, according to the content of the major ions.

A personality test is a useful tool in recruitment contexts. Studies have shown that participants distort their answers in a socially desirable manner. The purpose of this study was to investigate if people respond more or less socially desirable depending on how they rate themselves in a personality test, based on the "big five" personality dimensions.Eighty people, (40 women and 40 men), 19-42 years, (M= 24,1 SD= 3,76) rated themselves on a personality test. Group one, (20 women and 20 men) completed the test on paper. Group two, (20 women and 20 men) completed the test verbally.

This is a study of the national test in 3rd grade. The national test is obligatory and is conducted in 5th and 9th grade, but since the spring of 2009 the tests also become mandatory in 3rd grade. The case study of this research is to find out how children in 3rd grade perceive the purpose of the national test. The survey should also clarify how students think and feel about the national test, and how they feel before the national test and after they have finished writing the test. Has the test positive or negative influence on children? The survey will also show how much teachers clarify what the significance of the national test is for the students.

Att genomföra ett test som alltid ger samma resultat kan i längden kännas omotiverat. Strauss test är ett test som funnits länge för att testa stålets känslighet mot interkristallin korrosion. I detta arbete har Strauss test utvärderats i syftet att få fram ett underlag som kan användas för att starta diskussioner om en förändring i provningsmetodiken. Anledningen till att en förändring behövs är att alla dessa, ej informativa, tester kostar pengar. För att få fram underlaget har en litteraturstudie och experiment genomförts.

This bachelor thesis includes two different manuals and design of an interface box between a test object and a general test station (computer) with ARINC429 communication.There are three different purposes with this project:The first is to setup a general test station with ARINC429 communication using a communications card from DDC (DD-42916i3-300) and software from Ampol Technologies (dataSIMS).The second is to design a new interface between the test computer and the test object. As well as implementing two components in the equipment.The third is to write two separate manuals to guide the users of this equipment. There are two different kinds of users of this equipment, technicians and system engineers. Technicians use the equipment to test and repair flight components. System engineers will implement new components in the equipment.The result of this project is a working test station with a new interface and two manuals..

Syfte: att undersöka om resultatet vid 6-minuters gångtest (6MWT) påverkades av ökad grad av uppmuntran.Metod: 30 friska personer ?60 år rekryterades via bekvämlighetsurval. Alla testpersoner genomförde tre 6MWT. Första testet var en försöksomgång. Ett test (test A) utfördes med standardiserad uppmuntran enligt American Thoracic Society(ATS).

Swedish school children exhibit deteriorating knowledge results in terms of reading comprehension. Previous research shows that a method to increase the level of knowledge is the use of evidence-based learning techniques. Test based learning generates what is commonly referred to as a test effect, which proved to strengthen the relationship between learning and memory, as well as being applicable to various test formats. The purpose of this study was to investigate whether test based learning, in terms of learning english words leads to increased performance in a reading comprehension test, more specifically a cloze test. The study was based on a within-group design and was conducted three times over four weeks.